Snap-on MG31 3/8 in Drive Pneumatic Air Impact Wrench 11000 rpm USA Made

Snap-on MG31 pneumatic impact wrench, 3/8 inch drive, in the red body finish. The compact gun techs keep for header bolts, brake hardware and anything a 1/2 inch impact is too bulky to reach. The model number MG31 is cast into the side of the housing and the intact factory warning plate on the back reads 90 PSIG / 6.2 BAR MAX, Snap-on Kenosha WI USA, 11,000 r/min. Forward and reverse regulator on the back plate, trigger throttle, molded rubber grip, pin style anvil. Roughly 6.5 inches long. Condition: used shop tool, sold as-is and untested. Cosmetically rough. The red finish is chipped and worn back to bare metal over much of the housing, with shop grime in the casting and in the grip texture. Functionally everything is there: the warning plate is intact and fully readable, the MG31 casting is crisp, the anvil turns, and the regulator and trigger both move. It has not been run on air here, so plan on an oiling before use. Photos show the exact tool you receive and the paint loss is exactly as pictured.