Snap-on Right Angle Air Die Grinder Pneumatic 90 Degree 20000 RPM Made in USA

Snap-on right angle pneumatic die grinder, made in USA. The Snap-on logo is molded into the red cushioned grip sleeve along with a 20,000 RPM rating, and USA is molded near the head. Inline body about 7 inches long with a black right angle head, a safety lever throttle along the top, a collet and collet nut at the spindle, and a threaded air inlet at the tail. The right angle head is what earns its place in a shop: it gets a burr or a stone into corners and against flat work where a straight grinder cannot reach. Condition is heavily used. The red grip sleeve is worn through to bare metal in several places, grime and debris are packed into every crevice, and the black head sections carry surface rust. The throttle lever is present and moves and the spindle threads and collet look intact. It has not been run on air, so it is sold untested and as-is, despite an earlier draft of this listing saying otherwise. No collet wrench, burrs or accessories are included. The collet size was not measured; Snap-on's right angle die grinders are a 1/4 inch collet line, but confirm before ordering bits.